Peptide Reconstitution
Instructions
These guidelines describe the standard laboratory procedure for reconstituting lyophilized peptides using bacteriostatic water. Proper sterile technique and laboratory handling procedures should always be followed.
 Supplies Needed
Lyophilized peptide vial
Bacteriostatic water
Sterile syringe
Alcohol prep pads
Sharps container
 Step-by-Step Reconstitution Process
01
Wash hands thoroughly and prepare a clean working surface.
02
Use an alcohol prep pad to sanitize the rubber stoppers of both the peptide vial and the bacteriostatic water vial.
03
Draw the desired amount of bacteriostatic water into a sterile syringe.
04
Insert the syringe needle through the rubber stopper of the peptide vial.
05
Slowly inject the bacteriostatic water down the inside wall of the vial to avoid spraying directly onto the lyophilized powder.
06
Allow the bacteriostatic water to gently dissolve the peptide powder.
07
Do not shake the vial, as this may damage the peptide structure.
08
If necessary, gently swirl the vial until the peptide is fully dissolved.
 Important Handling Notes
- Do not shake peptide vials vigorously.
- Gentle swirling is recommended.
- Always maintain sterile technique when handling research compounds.
- Store reconstituted peptides according to recommended storage conditions (commonly refrigerated).
- Dispose of used syringes and sharps in an approved sharps container.
 Storage Guidance
Lyophilized peptides should typically be stored in a cool, dry environment before reconstitution. After reconstitution, peptides are commonly stored in a refrigerator to maintain stability and integrity during research use.
Research Use Disclaimer
All products sold by Peptide Fix are intended strictly for laboratory research purposes only. These products are not approved for human or veterinary use. Proper laboratory safety protocols should always be followed when handling research compounds.